How Do You Put Yard Signs in Frozen Ground?

Make two pilot holes first: drive a long screwdriver, a piece of rebar or a long drill bit about eight inches into the ground, ten inches apart, then push the legs of the steel H-stake into the holes and slide the sign down onto it. Never hammer on the sign itself. If the frost is only an inch or two deep, a rubber mallet on the stake’s crossbar is enough.

Five ways that work

1. Pilot holes. Two holes ten inches apart (the width of the stake), six to eight inches deep. A long screwdriver and a hammer, a foot of 3/8″ rebar, or a cordless drill with a long masonry bit all work. This is what crews who set signs all winter do.

2. Mallet on the crossbar. For a light frost, set the stake alone and tap the lower crossbar with a rubber mallet. Slide the sign on afterwards.

3. Warm water. A kettle of warm water on the spot softens the top couple of inches for a few minutes. When it refreezes it grips the stake, which is a help, not a problem.

4. The snowbank. Pack the stake into a firm, plowed bank or a shoveled pile. It stands until the thaw; reset it afterwards.

5. A bucket. Where there is no ground at all — a paved lot, a plaza entrance — push the stake into a five-gallon bucket of sand or gravel.

What not to do

Do not push or hammer on the top edge of the sign: the corrugated plastic crushes and the sign folds. Set the stake first, then slide the sign over the two upright wires, which run up inside the flutes.

Do not set it in the plow line. Three or four feet back from the edge of the road, and clear of where the snow blower throws.

The easy answer: before the freeze

A stake pushed into soft ground in November is locked in solid by December. If you know where the signs are going — your own frontage, regular customers’ driveways, the plaza entrance — set them before the first hard freeze.

Ordering now: the proof comes back within 2–4 business hours, printing is the next business day after you approve it, and FedEx Ground usually takes two more business days. Ten signs with stakes are $95.

Where a stake will never go

On a chain-link fence or a railing, a vinyl banner with grommets and a bag of zip ties is the better tool: 3′ × 6′ is $70. On a sidewalk, an A-frame with two printed inserts is $249 and needs no ground at all.

Questions people ask

Can you hammer a yard sign stake into frozen ground? Only the stake, never the sign, and only with a rubber mallet on the lower crossbar. In hard frost the wire bends before it goes in; make two pilot holes with a screwdriver, rebar or a drill first.

How deep should the stake go? Six to eight inches. Deep enough that the bottom edge of the sign sits close to the ground or the snow, which keeps the wind from working it loose.

Will the sign stay up once the ground freezes around the stake? Yes, frozen ground holds a stake harder than soft ground does. Signs come loose in the thaws; walk the route after a warm spell and push them back down.

Do your signs come with stakes? Yes. Every sign ships with a 10″ × 30″ steel H-stake in the box at no extra charge: 10 signs for $95, 25 for $219.

This winter

More winter work: who orders yard signs in winter, and when · ready-made designs by trade.

At a glance

10 yard signs, single / double sided$95 / $125
25 yard signs, single / double sided$219 / $279
50 yard signs, single / double sided$399 / $499
Sign24″ × 18″ 4mm coroplast, full color, edge to edge
StakesOne 10″ × 30″ steel H-stake per sign, included
ProofFrom a designer, 2–4 business hours; nothing prints until you approve it
ShippingFree FedEx Ground to the lower 48, usually 2 business days

When something else works better

  • You need one or two signs. Our smallest pack is ten; a local print shop will make one.
  • You need them tomorrow. We print the next business day after you approve the proof and FedEx Ground usually takes two more; a local shop that prints the same day is faster.
  • You want hundreds in one run. Our prices are built for 10 to 50 signs. Above 100, a bulk printer prices lower.

Order yard signs

Upload a file or start from a ready-made design; a designer emails a proof within 2–4 business hours. 10 for $95, 25 for $219, a stake in every sign, shipped free.

Order 10 for $95 →

Related questions